PVD镀膜上架的时候一定要把夹具上到位既要让产品固定好也不能挡到需要真空电镀的位置。

PVD镀膜有专用夹具是比较好的底漆喷涂处理，PVD镀膜喷枪的位置还有油漆调好准备好就可以上线了，PVD镀膜上线的时候一定要注意尽量避免手接触产品。

PVD真空镀膜处理可以做导电和不导电两种工艺，PVD镀膜时间长短厚度大小都要把握好。

PVD镀膜面漆喷涂处理比较后一次做喷涂进行保护PVD镀膜层。

客户需要不同的颜色都是要在面漆上边做出来的。PVD镀膜面漆喷涂上线的时候一定要注意不能用手触摸产品，因为刚PVD镀膜处理表面没保护电镀层很容易刮花，脱落。

公司目前主要针对，五金餐具，日用厨具，汽车零部件，五金锁具，医疗器械，五金卫浴，电子产品等产品的表面真空镀膜。

When PVD coating is put on the shelf, the fixture must be in place, so that the product can not be fixed and can not be blocked to the position requiring vacuum plating.

PVD coating has a special fixture, which is the best primer spraying treatment. The position of PVD coating spray gun and the paint can be put on the line when it is ready. When PVD coating is put on the line, you must pay attention to avoiding hand contact with the product as far as possible.

PVD vacuum coating treatment can be conducted in two processes: conductive and non-conductive. The length of PVD coating time and thickness should be well controlled.

PVD coated finish paint shall be sprayed for the last time to protect the PVD coating.

The customer needs different colors to be made on the top of the finish. When the PVD coating finish is sprayed on the line, it must be noted that the product cannot be touched by hand, because the newly PVD coating surface is not protected, and the electroplating layer is easy to scratch and fall off.

At present, the company mainly focuses on the surface vacuum coating of hardware tableware, daily kitchenware, auto parts, hardware locks, medical instruments, hardware sanitary ware, electronic products and other products.